Unscrew the pneumatic coupling on the hotend and remove the Bowden tube. Heat the nozzle a little hotter than the last filament you used. Decrease the value by 0.1, then press the wheel to move the nozzle to the new position.First try the easy stuff. Turning the knob to the left raises the bed towards the print nozzle, turning it to the right lowers the bed.Place a sheet of paper under the nozzle, then move the Z position ( Prepare » Move Axis » Move Z) to 0 (the auto home will end with Z around 10mm). There are 4 knobs, one on each corner of the bed, that will raise and lower that corner. Infill Ender 5 (Plus/Pro)Once the printer is assembled the next vital step is to make sure the bed is level in relation to the print head. If you want to test the limits of your Ender 5, you can try the 0.08 mm as a layer height. So the above profiles are already very well distributed over this range. The minimum layer height is therefore 0.1 mm. G1 X- 47.5 Y14 F6000 go to first bed probe point and home Z G30 home Z by probing the bed.The maximum layer height with a standard 0.4 mm nozzle is 0.3 mm according to the 25%-75% rule.
The dive height of 2.5mm is a little low. The BLTouch instructions say that it should be installed so that the base of the probe body should be 8mm above the nozzle tip.
0 kommentar(er)
